Call Forward; Call Forward Settings Configuration - Yealink SIP-T5 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
Parameter features.play_mute_tone.enable
Description It enables or disables the phone to play an audible tone when the mute status is changed.
0-Disabled
Permitted
Values
1-Enabled
Default 0
Supported
CP920
Devices
Parameter features.play_mute_tone.interval
It configures time interval (in seconds) for playing an audible tone when the phone is in the mute state
Description
during the call.
Permitted
Integer from 3 to 3600
Values
Default 5
Supported
CP920
Devices

Call Forward

You can forward calls from any line on your phone to a contact. There are two ways of forwarding your calls:
Forward calls in special situations, such as when the phone is busy or there is no answer, or forwarding all
l
incoming calls to a contact immediately.
You can set the phone not to forward a call coming from authorized numbers.
Manually forward an incoming call to a number.
l
Topics

Call Forward Settings Configuration

Call Forward Feature Configuration
Call Forward Synchronization for Server-side Configuration
Call Forward Settings Configuration
You can change the following call forward settings:
Enable or disable the call forward feature. If disabled, the users have no permission to configure call forward on
l
their phone.
Choose a call forward mode. You can configure call forward for all lines or specific lines.
l
Allow or disallow users to forward an incoming call to an international telephone number (the prefix is 00).
l
Enable or disable forward emergency feature and specify forward authorized numbers. These numbers will not
l
be forwarded when the call forward feature is enabled. The incoming call will not be logged in the Forwarded
Calls list.
Enable or disable the display of the Diversion header. The Diversion header allows the phone which receives a
l
forwarded-call to indicate where the call was from.
The following table lists the parameters you can use to change the call forward settings.
Parameter features.fwd.allow
Description It enables or disables the call forward feature.
Permitted
0-Disabled, call forward feature is not available to the users.
Values 1-Enabled
397
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg