Sending Volume Configuration - Yealink SIP-T5 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones

Sending Volume Configuration

You can configure the sending volume of currently engaged audio devices (handset, speakerphone or headset)
when the phone is in use.
The following table lists the parameters you can use to configure the sending volume.
Parameter voice.handfree_send
It configures the sending volume of the speaker.
Description
Note: We recommend that you modify this parameter cautiously. An unsuitable value may render the
voice quality bad.
Permitted
Integer from -50 to 50
Values
Default 0
Web UI Features > Audio > Handfree Send Volume (-50~50)
Parameter voice.handfree.autoreset_spk_vol
Description It configures the speaker's volume level during a call.
0-The speakerphone volume at the end of a call persists between calls.
Permitted
1 to 15-The speakerphone volume does not persist between calls, and resets to this specified level
Values
each new call.
Default 0
Parameter voice.handset_send
It configures the sending volume of the handset.
Description
Note: We recommend that you modify this parameter cautiously. An unsuitable value may render the
voice quality bad.
Permitted
Integer from -50 to 50
Values
Default 0
Supported
All phones except CP920
Devices
Web UI Features > Audio > Handset Send Volume (-50~50)
Parameter voice.handset.autoreset_spk_vol
Description It configures the handset's volume level during a call.
0-The handset volume at the end of a call persists between calls.
Permitted
1 to 15-The handset volume does not persist between calls, and resets to this specified level each
Values
new call.
Default
0
Supported
All phones except CP920
Devices
Parameter voice.headset_send
It configures the sending volume of the headset.
Description
Note: We recommend that you modify this parameter cautiously. An unsuitable value may render the
voice quality bad.
157
[1]
[1]
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg