Multiple Call Appearances; Multiple Call Appearances Configuration - Yealink SIP-T5 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
It enables or disables the DND feature synchronization for account X.
Note: The value configured by this parameter takes precedence over that configured by the parameter
Description
"features.dnd.feature_key_sync.enable". It works only if "account.X.feature_key_sync.enable" is set to
1 (Enabled).
0-Disabled
Permitted
Values
1-Enabled, server-based DND is enabled. Server and local phone DND are synchronized.
Default Blank
Supported
All phones except T48G, T46G, T42G, T41P, T29G and CP920
Devices
Parameter features.dnd.feature_key_sync.local_processing.enable
It enables or disables the local DND when DND feature synchronization is enabled.
Note: It works only if "features.feature_key_sync.enable" and "features.dnd.feature_key_sync.enable"
Description
are set to 1 (Enabled). The value configured by the parameter "account.X.features.dnd.feature_key_
sync.local_processing.enable" takes precedence over that configured by this parameter.
0-Disabled, DND is performed on the server side only.
Permitted
Values
1-Enabled, DND is performed on both the server side and locally.
Default 0
Parameter account.X.features.dnd.feature_key_sync.local_processing.enable
It enables or disables the local DND when DND feature synchronization is enabled.
Description
Note: It works only if "features.feature_key_sync.enable" and "features.dnd.feature_key_sync.enable"
are set to 1 (Enabled).
0-Disabled, DND is performed on the server side only.
Permitted
Values
1-Enabled, DND is performed on both the server side and locally.
Default Blank
[1]
X is the account ID. For T57W/T54W/T48U/T48S/T48G/T46U/T46S/T46G/T29G, X=1-16; for
T53W/T53/T43U/T42U/T42G/T42S, X=1-12; for T41P/T41S/T27G, X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21
(P) E2, X=1-2.

Multiple Call Appearances

You can enable each registered line to support multiple concurrent calls. For example, you can place one call on
hold, switch to another call on the same registered line, and have both calls displayed.
You can set the maximum number of concurrent calls per line key on all-lines basis or a per-line basis. For
example, if you specify 3 concurrent-calls for account 1, you can only have three call appearances on a cor-
responding line key. The additional incoming calls will be rejected.
Note
: The number of concurrent calls applies to all line keys. For example, if three line keys are associated with an account,
you can have three call appearances per line key.
Topic

Multiple Call Appearances Configuration

Multiple Call Appearances Configuration
You can specify the maximum concurrent calls per line key.
The following table lists the parameters you can use to configure multiple call appearances.
391
<y0000000000xx>.cfg
[1]
<MAC>.cfg