Replacing the Front Belt
Dismantling
The entire belt is removed according to the
following when a snow blade is to be
attached to the machine.
1.
Put the cutting unit in the service
position.
2.
Pull the centre belt off of the centre
pulley. The belt becomes slack when the
cutting unit is lifted.
3.
Take off the front belt from the centre
pulley and remove the belt.
Assembly
1.
Position the belt from the front. Pull the
belt on the outside of the runner pulley
and on the inside of the adjuster pulley.
2.
PF 21 and PF 21 AWD
If PF 21 or PF 21 AWD is to be used with
an accessory or with the cutting unit
CombiTurf 112, the belt should be pulled
on the outside of the outer runner wheel,
otherwise the belt will be too long.
78
English-
REPAIR INSTRUCTIONS
Service position
Belt tightening
Runner and tension wheels