External Ftp Server Settings - VBrick 9000 Admin Manual

Field
Primary Server IP Address
Secondary Server IP Address Secondary host name (VBrick Host Name or DNS Host
Note: DHCP Option 4 (TIME) and Option 42 (NTP) are requested from the DHCP
server to obtain SNTP server addresses. One or both of these options must be
enabled in the DHCP server for these addresses to be returned to the encoder. If both
are returned, the encoder will use the NTP server address. If the DHCP server
configuration is unknown, it is recommended that the address(es) be manually entered
since the DHCP server-supplied address will always override a manually-entered
address.
Network Page Topics:

Network
Domain Name Server Settings
Network Time Synchronization Settings

External FTP Server Settings

External FTP Server Settings
To access the

1. Navigate to
An external FTP server can be used with an Archiver in order to FTP recorded streams to a
remote server. See the Archivers topic for more about this functionality.
The
FTP Server User Name
If they are not entered the same as what is set up on the server, the encoder will be unable to
connect and perform the transfer.
VBrick 9000 Encoder Admin Guide
Description
Primary host name (VBrick Host Name or DNS Host
Name) or IP address of valid SNTP server providing time
synchronization. A blank field indicates the server address
will be acquired via the DHCP server only if the
field above is checked.
DHCP
Name) or IP address of valid SNTP server providing time
synchronization. A blank field indicates the server address
will be acquired via the DHCP server only if the
field above is checked.
DHCP
fields:
External FTP Server
>
System Configuration
and
Password
>
Network External FTP Server
must be set up properly on the remote FTP server.
System Configuration
Network
Network
section.
17