Snmpv3 Passwords - VBrick 9000 Admin Manual

Field
Destination
Dedicated Destination Shown if Dedicated is selected above. The VBrick encoder (whose
Dedicated Port
Baud Rate
Stop Bits
Parity
COM Interface Type
RTS Control
DTR Control
Operational State

SNMPv3 Passwords

To access the

1. Navigate to
44
Description
• Dedicated – Use when the destination is a dedicated network
destination such as another VBrick encoder. Enter Host Name
or IP Address in Dedicated Destination field below.
• KLV – The serial port accepts LDS (Local Dataset Packets) or
CoT (Cursor on Target) metadata. For more about this topic,
see Key Length Value (KLV) Metadata on page 169.
serial port is the destination of this COM port) can be configured
and identified using either an IP address or a Host Name. If Host
Name is used, the Resolved Destination IP Address field shows
the read-only IP address of the VBrick encoder.
• COM1 – Default = 4414
• COM2 – Default = 4439
Rate of Passthrough port. Rate can be set to the following (Default
= 9600): 110, 300, 600, 1200, 2400, 3600, 4800, 7200, 9600, 14400,
19200, 28800, 38400, 57600, 115200.
Number of stop bits for Passthrough port (1 or 2).
None, Even, Odd.
Describes the COM interface connector.
• RS232 – standard RS-232 serial port connector.
• RS422/485 – RS-422/485 4-wire serial port connector.
Force Off, Force On or Automatic. If automatic, the control will
be on when Passthrough is active.
Note: DTR and RTS are not available for COM. Under no
conditions are RTS or DTR controls passed through end-to-end.
All control handling is local.
Force Off, Force On or Automatic. If automatic, the control will
be On when Passthrough is active. See note above.
Describes the current status of a Passthrough connection,
including error conditions, if any. Refer to the Monitor > Monitor
the Network page. This will display "Active" if in Passthrough
mode.
fields:
SNMPv3 Passwords
>
System Configuration Advanced Configurations
> .
SNMPv3 Passwords
© 2015 VBrick Systems, Inc.