System Configuration; Network - VBrick 9000 Admin Manual

System Configuration

Network

To access the

1. Navigate to
Field
IPv4 DHCP
IPv4 Address
IPv4 Subnet Mask
IPv4 Gateway Address
VBrick 9000 Encoder Admin Guide
fields:
Network
>
System Configuration
Description
Default =
Enabled
DHCP is enabled, the encoder gets its IP Address, Subnet Mask,
and Gateway from the DHCP server. If the DHCP server
supplies the DNS server address, these parameters will replace
the user-entered DNS settings. If DHCP is enabled and the
encoder cannot obtain an IP address from the server, it will start
in limited run mode after 90 seconds, using its default IP Address
of . After 15 minutes, it will automatically reset and
172.17.5.5
again attempt to acquire an address. The LCD screen on the front
of the encoder will indicate a DHCP failed message. Note: The
VBrick encoder requires a minimum DHCP lease length of 8
minutes to work, however it is recommended to extend the lease
time to what is maximally available via the network to avoid
disruptions.
This is either a static or a DHCP-enabled IPv4 IP address.
Subnet mask for the encoder address.
Gateway IP Address for communicating across different network
segments.
.
Network
. Dynamic Host Configuration Protocol. If
Chapter 2
13