Transmitter External Announce Settings - VBrick 9000 Admin Manual

Field
Send to Unicast Destination
Destination IP Address
Destination Port
Transmitters Page Topics:

RTMP Transmitter
Auto Unicast Transmitter Mode
Enable Forward Error Correction (FEC) on a Transmitter
Smooth Streaming Transport Type
Transmitter Announce Settings

Transmitter External Announce Settings

Transmitter External Announce Settings
To access

External Announce Settings
1. Navigate to
These settings configure an external announcement that can be used when the stream is
reflected to a third-party server or a VBrick reflector.
Field
External Announce
Use Global Announce IP and Port
VBrick 9000 Encoder Admin Guide
Description
If enabled and the destination is unicast, the unicast
IP address is used for the announcement and the
Destination field is greyed out. Default = Disabled.
The destination IP Address or Host Name the
announcement is sent to. By default, the
announcement is sent to the multicast network. If
using an VEMS Portal Server, enter the Portal Server IP
address.
The destination port the announcement is sent to.
>
Encoder Configuration
Description
This section is used to announce RTSP streams to a
network device outside of the broadcast domain.
Use Announce Settings (IP Address for Transmitters
and Port) defined on Encoder Configuration >
Programs page. If checked, the Destination IP
Address and Destination Port fields are greyed out.
fields for a :
Transmitter
>
Transmitters External Announce Settings
Encoder Configuration
section.
99