Operational Modes - VBrick 9000 Admin Manual

The
Operational Mode
to run this test. When done, be sure to reset the encoder to Run mode or you
Diagnostics
will not be able to stream video.
To run the Device Test:

1. Navigate to System Configuration > General and set the
. (See: Operational Modes)
Diagnostics
2. Navigate
Troubleshoot
3. Set the test parameters (see below).
4. Click and wait a few seconds to see the test results.
Start
5. When done go back to System Configuration > General and set the
.
Run
Field
Current Test
Number of Loops to Run
Failure Count
Intensity
VBrick Debug Information
File

Operational Modes

The encoder has five operational modes that reflect differing conditions.
Diagnostics Mode
Maintenance Mode
certain conditions occur.
Mode
Run Mode
166
(on the System Configuration > General page) must be set to
>
Device Tests
Description
As displayed.
Number of times to run the test.
Number of items that failed.
Low intensity is faster but runs fewer tests. High intensity
runs all tests but may take 30 minutes or more.
Click button to generate a debug file. When requested by
VBrick Support Services, you will need to fetch multiple files
via FTP.
are user-selectable on the System Configuration > General page.
, , and
Limited Run Mode Overloaded Mode
Description
This is the standard operating mode when the system is functioning
normally. If you power up the encoder under normal conditions,
the system will be in Run mode.
Operational Mode
and click .
Edit
are automatically launched when
to
to
Operational Mode
and
Run Mode
© 2015 VBrick Systems, Inc.