Servers - VBrick 9000 Admin Manual

Field
Destination IP Address
Destination Port
URL
Transmitters Page Topics:

RTMP Transmitter
Auto Unicast Transmitter Mode
Enable Forward Error Correction (FEC) on a Transmitter
Smooth Streaming Transport Type
Transmitter Announce Settings
Transmitter External Announce Settings

Servers

To access the

1. Navigate to
The VBrick 9000 encoder is also a streaming server and can be controlled by a remote
decoder client via RTSP and RTCP protocols. In server mode, a served stream does not
become active on the network until requested by a client. The client may be a software player
like StreamPlayer, or a QuickTime player on a PC or a Macintosh. The user requests a stream
from the encoder by directing the decoder client to issue an RTSP request to the URL of the
VBrick H.264 encoder. The client and the encoder then exchange a sequence of RTSP
messages to direct the encoder to send the program to the client. Multiple servers are
available. A server references a stream to determine Transport Type, Program, Video Rate,
Audio Rate, and other parameters. A server can be configured as RTP or MPEG2TS
(Transport Stream). RTMP and Smooth are not supported. An RTP server also accepts RTSP
interleaved and HTTP tunneled requests from a client.
Note: In server mode, a program stream is pulled from a server. In this mode, a served
program does not become active on the network until requested by a decoder client
like StreamPlayer or QuickTime.
100
Description
The destination IP Address or Host Name the
announcement is sent to. If using an VEMS Portal
Server, enter the Portal Server IP address. If using a
reflector, enter the reflector server IP address.
The destination port the announcement is sent to.
The URL of the reflector (i.e the source of the
reflected stream). This URL is embedded in the
announcement.
fields:
Servers
>
Encoder Configuration
.
Servers
© 2015 VBrick Systems, Inc.