Use An External (Usb) Device To Archive A Stream - VBrick 9000 Admin Manual

in the batch. When batch mode is disabled,
the (one) file and the
The
Archive Duration
if the duration is set for 1800 seconds (1 hour), the archiver will start writing over the
previously recorded files after an hour. If set to
over the previously recorded files when it reaches the
of files).
Note: If the archiver encounters an interruption in file transfer during batch
recording, the file being recorded and the next file will both be affected. The file in the
process of being replaced will be partially recorded. The next sequential file that was
deleted to get ready for receiving data will be missing.
Archivers Page Topics:

Enable Batch Mode and Archive a Batch File

Use an External (USB) Device to Archive a Stream

Use an External (USB) Device to Archive a Stream
The external storage devices shown in Table 1 below have been tested and verified by
VBrick. Devices from other manufacturers may work but have not been tested and are not
supported. USB devices are portable and can be easily moved to any compatible device with
a USB port. USB storage devices must be formatted before initial use and must be safely removed when
done.
Note: The encoder only supports external drives with one partition. If you insert a
drive with more than one partition, only the first partition will be used. This will not
affect drive performance and you can safely ignore the "
message.
To attach and configure an external storage device:

1. Connect a recommended external storage device to the USB port on the encoder (or to a
blade in a rack mount shelf) using the vendor-provided cable.
2. Go to the Monitor > Monitor the System page and click
3. Click
Format
to
Formatted
4. When ready you can enable the archiver and stream to the device as necessary.
5. When done go back to the to the Monitor > Monitor the System page, click
wait for a message before you can safely remove the device.
Note: Versions of 9000 Series hardware prior to 3.0 do not reliably support USB hard
drives that are powered from the USB port (and do not have their own power supply.)
Board Assemblies 6106-0000-0200 and higher do support USB-powered hard drives.
To check your
Information page.
VBrick 9000 Encoder Admin Guide
setting is not used.
Batch Duration
can be set to a specific number of seconds or
in the External device column and wait for the status to change from
. This may take a few moments depending on the size of the device.
Board Assembly Number
controls the time recorded into
Archive Duration
Continuous
, the archiver will start writing
Continuous
(i.e. the maximum number
Wrap Point
Failed to mount
.
Edit
go to the Monitor > Monitor Manufacturing
Encoder Configuration
. For example,
" or similar
None
, and
Eject
105