Transmitter Announce Settings - VBrick 9000 Admin Manual

Field
Generated Smooth Streaming
Event Id
Transmitters Page Topics:

RTMP Transmitter
Auto Unicast Transmitter Mode
Enable Forward Error Correction (FEC) on a Transmitter
Smooth Streaming Transport Type

Transmitter Announce Settings

Transmitter External Announce Settings
Transmitter Announce Settings
To access

Announce Settings
1. Navigate to
This section contains parameters that are used to modify announcements from the encoder.
Announcements are advertisement packets that are transmitted by VBrick encoders to other
VBrick encoders and VBrick applications such as the VEMS Portal Server or StreamPlayer.
An announce is also required if you will be streaming to a VBrick 9000 Series decoder. They
are used to identify VBrick streams present in the network.
RTP and MPEG2TS;
Field
Announce
Use Global Announce IP and Port
98
Description
Read-only. This auto-generated string is used to facilitate
backup encoders streaming to the same IIS server.
fields for a
>
Encoder Configuration
External Announce
Description
RTP and MPEG2TS only. This section is used to
announce the stream to the local network allowing
viewable announcements in programs like
StreamPlayer, VBDirectory, or a 9000 Series decoder.
The unit must be on the same segment of the network
or the router must be configured to retransmit
broadcast packets for the announcements to be
accessible using the IP address 255.255.255.255.
Use Announce Settings (IP Address for Transmitters
and Port) defined on Encoder Configuration >
Programs page. If checked, the Destination IP
Address and Destination Port fields are greyed out.
:
Transmitter
>
Transmitters Announce Settings
Announce Settings
is used with all transport types.
section.
are used with
© 2015 VBrick Systems, Inc.