VBrick 9000 Admin Manual page 99

Field
Destination
RTP Encapsulation Enable
RTCP Transmit
RTCP Transmit Interval
Destination Video Port
Destination Audio Port
Destination Port
Announce Session Name
Override
VBrick 9000 Encoder Admin Guide
Description
Select IP Address or Host Name from the dropdown. The
actual IP address determines whether the stream will be
multicast (e.g. 239.22.118.72) or unicast (e.g. 127.22.118.72).
Default = 127.0.0.1 (loopback). For guidance on selecting
multicast address, see the Getting Started Guide >
Assigning a Multicast Address section. If using a Host
Name, you must configure a Domain Name Server on the
System Configuration > Network page.
If Auto Unicast, the following caveats apply: (1) this field is
the Host Name or IP address of the streaming server; (2)
this field does not support multicast IP addresses.
Use to configure MPEG2TS transmitters to be RTP
encapsulated before transmission. FEC requires RTP
Encapsulation. Consequently when you enable FEC Stream
1 or FEC Stream 2, RTP Encapsulation is auto-enabled and
this parameter is hidden. Conversely, if you do not enable
FEC Stream 1 or Stream 2, you still have the option to
enable RTP Encapsulation if desired. Default = Disabled.
RTP and MPEG2TS. Allows RTCP sender reports
(containing transmission and reception statistics for all RTP
packets) to be sent from the VBrick encoder. Default =
Enable.
RTP and MPEG2TS. When RTP Encapsulation is enabled,
this parameter tells the encoder how often (in seconds) to
send RTCP reports. Default = 10 seconds.
RTP only. Destination video port for this transmitter. Note
that viewing a unicast and multicast stream (configured on
different transmitters) on the same PC or the same decoder
may not work if the transmitter ports are the same.
RTP only. Destination audio port for this transmitter.
RTMP and MPEG2TS only.
RTP and MPEG2TS. Lets you replace the Program Name
(on Encoder Configuration > Programs page) with a new
name to be used in session announcements, SDP files, and
RTSP Describe responses. This is especially useful in
multiple bit rate streaming.
Rather than having all transmitters use the same Program
Name for announcements, an administrator can optionally
assign a unique name to each transmitter. Default = blank.
This means the Program Name will be used.
Note: There is no validation for unique names. If using this
feature, the administrator is responsible for creating unique,
individual names for each transmitter.
Encoder Configuration
91