VBrick 9000 Admin Manual page 22

Field
Host Name
Management IP Version •
IPv6 Configuration
Method
IPv6 Resolved Address
IPv6 Address
IPv6 Network Prefix
Length
IPv6 Gateway Address
DHCP Retry Interval
14
Description
The Host Name defaults to the Media Access Control (MAC)
address, a hardware address that uniquely identifies each node of
a network. The encoder Host Name identifies the encoder to
various network applications including DHCP, SNMP and VBrick
application tools. The Host Name can be a maximum of 18
characters; the first character must be a letter and the rest can be letters,
numbers, or hyphens.
– Use an IPv4 address. Default.
IPv4 Only
• – Use both IPv4 and IPv6 addresses. Complete
IPv4 and IPv6
additional fields that are then displayed for IPv6 as required.
Displayed if
Management IP Version
the IPv6 Configuration Method. Note that IPv6 is supported on
VBAdmin, Web Services, SNMP, and Telnet. Ipv6 is not
supported on SNMP notifications, Announcements, Management
SAPs, and Streaming.
• – The device will auto-configure the IPv6 address
Auto Config
using the (NDP) MAC-based address. Default
• – The device will use an external IPv6 DHCP server.
DHCPv6
• – Use to manually set IP address.
Static Assignment
Displayed if IPv6 Configuration Method above is
.
DHCPv6
Static Assignment only. Manually enter an IP address.
Static Assignment only. Manually enter the network prefix length.
Static Assignment only. Manually enter the Gateway Address.
Displayed when
Show advanced settings
to adjust the time (in minutes) before the encoder will reset and
attempt to acquire an IP address. Range 3–15. Default = 15.
above is . Select
IPv4 and IPv6
Auto Config
clicked. See above. Use
© 2015 VBrick Systems, Inc.
or