Monitor Transmitters - VBrick 9000 Admin Manual

Global
Field
Global Override
Current System Bandwidth The actual bandwidth currently being sent to the network.
Peak System Bandwidth
Current Number of Served
Clients
Peak Number of Served
Clients
Current Number of Active
Transmitters
Streams
Field
Stream Name
State
Actual Bit Rate
Video Buffer Full Count
Audio Buffer Full Count
Closed Caption Buffer
Full Count
Metering Buffer Full Count Increments when the metering buffer is full. If full, lower the
Refresh
Reset Counters

Monitor Transmitters

To monitor

1. Navigate to
The
Monitor Transmitters
that when more than 5 transmitters are configured, auto-refresh is disabled and you must use
the button to manually refresh the page.
Refresh
152
Description
Read-only. This parameter is configured on the Encoder
Configuration > Programs page.
The highest bandwidth sent to the network since the last time
these parameters were Reset.
Current number of HTTP and/or RTSP clients connected to
all servers.
Highest number of HTTP and/or RTSP clients that were
concurrently connected since the last time these parameters
were Reset.
As displayed.
Description
Defined on Encoder Configuration > Streams page. Click
hyperlink to jump to Streams page.
Enabled | Disabled.
Measured packetized bit rate.
These values increment when the stream's Video, Audio, or
Closed Caption buffers overflow. This usually indicates an
overload condition. If this happens reduce the load by
lowering the video Target Bit Rate or reducing the number of
transmitter-served clients or archivers.
Metering Aggressiveness value on the Encoder Configuration
> Streams page.
Refresh all counters.
Reset all counters to zero.
:
Transmitters
>
Monitor Encoder Status
page displays the program status of all defined transmitters. Note
> .
Transmitters
© 2015 VBrick Systems, Inc.