Monitor An Encoder With The Iphone App; Run A Script - VBrick 9000 Getting Started Manual

Monitor an Encoder with the iPhone App

Be aware that to use the iPhone app, your iPhone must be on the same wireless network as
the 7000/9000 encoder.
To launch the VBrick iPhone app:

1. Tap on the VBrick icon to launch the app. The page will show any 7000/9000 Series
devices that have manually added or discovered.
2. Click on the
Address, and login credentials. When done select a
3. Tap on any available device to see the home page for the device.
4. Click on the
Channel. This will display (below right) the relevant status values for the selected
Channel. These values are read-only and cannot be changed.

Run a Script

The iPhone app supports four predefined scripts that you can use to modify encoder
configuration parameters. (This is the only way you can modify parameters using the iPhone
app.) After you create and FTP these scripts (to the
use them to modify configuration parameters on the encoder. You run the script by tapping
the icon.
Control
54
icon to manually add devices. You will be prompted for Name, IP
button to display a list of Channels and then select any available
Monitor
is associated with script1,
F1
(if desired).
Default Device
folder on the encoder), you can
scripts
with script 2, etc. You can also change the
F2
© 2016 VBrick Systems, Inc.