Dip Switch Configurations; Denomination Acceptance Settings (Dip Switches At The Front); Sw1 And Sw2 Configurations; Interface Settings (Sub Board 1) - JCM GLOBAL UBA Pro Series Operation And Maintenance Manual

Section 2

DIP Switch Configurations

Denomination Acceptance Settings
(DIP Switches at the front)
Table 2-1 lists the default Front DIP Switches con-
figurations for the acceptable denominations.
NOTE: Front DIP Switch settings may vary
based on Software. Refer to each Country's
"Software Information Sheet" for making the
proper switch settings.
Table 2-1 Denomination Acceptance Settings
ON
OFF
Switch No. Switch ON/OFF
ON
1
OFF
ON
2
OFF
ON
3
OFF
ON
4
OFF
ON
5
OFF
ON
6
OFF
ON
7
OFF
*
8
OFF
*. Not Applicable (N/A). Never Switched to ON.

SW1 and SW2 Configurations

The UBA Pro CPU Circuit Board contains two (2)
DIP Switches that are located adjacent to one
another. The interface and the Recycler option can
be configured by these Switches (Figure 2-11).
NOTE: Refer to the UBA Pro RT/RQ Series
Banknote Recycler Operation and
Maintenance Manual for the Recycler
options.
Figure 2-11 SW1 and SW2 Switches
Bottom View
Figure 2-11 SW1 and SW2 Switches
P/N 960-000211R_Rev. A
UBA™ Pro Series Universal Banknote Acceptor

Interface Settings (Sub Board 1)

The SW1 switch equipped on the Sub Board 1 is to
set an interface RS232C or Photo-Coupler Isola-
tion (Table 2-2).
Description
VEND 1 INHIBIT
VEND 1 ACCEPT
VEND 2 INHIBIT
VEND 2 ACCEPT
Interface and Recycler Settings (Sub
VEND 3 INHIBIT
Board 2)
VEND 3 ACCEPT
The SW1 switch equipped on the Sub Board 2 is to
VEND 4 INHIBIT
set an interface RS232C, Photo-Coupler Isolation,
VEND 4 ACCEPT
I-TTL2 or ccTalk (Table 2-3).
VEND 5 INHIBIT
VEND 5 ACCEPT
VEND 6 INHIBIT
VEND 6 ACCEPT
VEND 7 INHIBIT
VEND 7 ACCEPT
OFF (Fixed)
*. Refer to the UBA Pro RT/RQ Series Operation and Maintenance Manual for using
the Recycler Unit(s).
SW1
SW2
2 - 4
NOTE: For the interface USB and TTL, no
need to configure the SW1 switch.
Table 2-2 Sub Board 1 Interface Settings
SW 1
Front
SW 2
Settings
SW1
-
SW2 Not available
NOTE: For the interface USB and TTL
(except for I-TTL2), no need to configure the
SW1 switch.
Table 2-3 Sub Board 2 Interface Settings
SW 1
Front
SW 2
Settings
SW1
-
SW2
© 2020, JAPAN CASH MACHINE CO., LTD.
Installation
Back
Description
Photo-Coupler Isolation
RS232C
USB, TTL
-
Back
Description
Photo-Coupler Isolation
I-TTL2
RS232C
cc-Talk
USB, TTL
(Except for I-TTL2)
To use a UBA Pro Unit
*
without a Recycler Unit(s)