Troubleshooting
Calibration
Program
UV (Transmissive)
Sensor
Calibration Program process
with Paper
failed.
06-YYYY-YYYY-YYYY-YYYY
Validation Sensor
Calibration Program process
non-Paper
failed.
UV (Transmissive)
Sensor
Calibration Program process
non-Paper
failed.
Position Sensor
Calibration Program process
failed.
Calibration Error Codes; Position Sensor
Table A-9 lists the various Error Code causes and solutions for the Position Sensor.
Sensor/Error
Entrance Sensor
Calibration Program
process failed.
P/N 960-000211R_Rev. A
UBA™ Pro Series Universal Banknote Acceptor
Table A-8 Calibration Program Error Codes (Continued)
Error Code and
Causes
•
•
05-00-00-00
•
•
•
•
•
•
•
•
07-00-00-00
•
•
•
•
09-ZZ-ZZ-ZZ
•
•
Table A-9 Position Sensor Calibration Error Codes
Error Code
•
Check that a correct Reference Paper is placed in a
proper direction. (Refer to "Placing Reference Paper"
on page 6-5.)
•
00-00-01
Check that a Reference Paper is not damaged or dirty.
(Refer "Reference Paper Handling" on page A-14.)
•
Check that the relative part is properly assembled and/
or Harness are connected.
•
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
Solutions
Check that a correct Reference Paper is placed in
a proper direction. (Refer to "Placing Reference
Paper" on page 6-5.)
Check that a Reference Paper is not damaged or
dirty. (Refer "Reference Paper Handling" on
page A-14.)
Check that the relative part is properly
assembled and/or Harness are connected.
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
Check that a correct Reference Paper is placed in
a proper direction. (Refer to "Placing Reference
Paper" on page 6-5.)
Check that a Reference Paper is not damaged or
dirty. (Refer "Reference Paper Handling" on
page A-14.)
Check that the relative part is properly
assembled and/or Harness are connected.
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
Check that a correct Reference Paper is placed in
a proper direction. (Refer to "Placing Reference
Paper" on page 6-5.)
Check that a Reference Paper is not damaged or
dirty. (Refer "Reference Paper Handling" on
page A-14.)
Check that the relative part is properly
assembled and/or Harness are connected.
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
Check that a correct Reference Paper is placed in
a proper direction. (Refer to "Placing Reference
Paper" on page 6-5.)
Check that a Reference Paper is not damaged or
dirty. (Refer "Reference Paper Handling" on
page A-14.)
Check that the relative part is properly
assembled and/or Harness are connected.
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
Solutions
© 2020, JAPAN CASH MACHINE CO., LTD.
A - 11
Appendix A
Relative
Parts/Sensors
•
UV Sensor
•
Line Sensor
•
UV Sensor
•
Position Sensor
Relative
Parts/Sensors
•
Entrance Sensor