Dip Switch Configurations; Basic Settings - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Section 2
Figure 2-3 Bezel Attachment
b
a
Figure 2-3 Bezel Attachment
NOTE: The bolt length are not to extend
more than 15mm up from the Host
Machine's base.
8. Remove the Course Path Reversing Guide and
bolt the VEGA SD/SU Unit into the VEGA SD/
SU Bracket installed on the Host Machine using
two (2) M4 Screws (Figure 2-4
(2) or four (4) M4 Hexnuts.
Figure 2-4 M4 Screw & Nut Removal Loca-
tions
Figure 2-4 M4 Screw & Nut Removal Locations
NOTE: The number of Screws required
depend on each Host Machine specification
requirements.
9. Seat the Cash Box (Figure 2-5 a) into the Frame
and replace the Course Path Reversing Guide
Cover (Figure 2-5 b) onto the Upper Section.
10. Turn the VEGA Unit Power
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
d
c
2
2
c
1 d
1
a & a ) and two
1 2
a
2
a
1
b
b
4
b
2
3
b
1
ON
.
Figure 2-5 Cash Box & Guide Cover Location
b
Figure 2-5 Cash Box & Guide Cover Location

DIP Switch Configurations

This portion provides the basic and special DIP
Switch settings for the VEGA Unit.

Basic Settings

To activate the ID-003, ccTalk or MDB Interface on
a VEGA Unit, set DIP Switch Block DS2 Switches
#6 through #8 to ON to select the desired Commu-
nications Interface Protocol (Table 2-2). Then set
DIP Switch Block DS1 Switches #2 through #8 to
ON to select the desired Banknote acceptance/
inhibit settings.
NOTE: The setting of Switches #2 through
#8 on DS1, and Switches #1 through #5 on
DS2 are decided by the Related Country's
Software Information Sheet.
Refer to the related Country's Software Information
Sheet for further Switch setting details.
Table 2-1 DIP Switch Block 1 Settings
DS1
Switch No. Switch ON
1 Test Mode
2
3
4
Refer to the Related Country's
5
Software Information Sheet
6
7
8
© 2016, JAPAN CASH MACHINE CO., LTD.
2 - 2
Installation
a
Switch OFF
Basic Performance