Connector Pin Assignment; Sub Board 1: Usb Connector Pin Assignment - JCM GLOBAL UBA Pro Series Operation And Maintenance Manual

Installation

Connector Pin Assignment

NOTE: Refer to "SW1 and SW2 Configurations" on page 2-4 to determine the Interface settings on
the CPU Circuit Board.

Sub Board 1: USB Connector Pin Assignment

Table 2-5 lists the UBA Pro Unit's Sub Board 1 USB Connector Pin Assignments.
Rear View
Pin No. Signal Name
Power
1
2 GND (Power)
3 M.RES
4
5 +12V (I/F)
6
7
8 VBUS1
9 DATA-1
10 DATA+1
11
12 GND (USB)
13 GND (SG)
14 LED POWER
15 VBUS2
16 DATA-2
17 DATA+2
18 LED -
19
20 SU SELECT
*. I/O (input/output) is the terminal as viewed from the Banknote Acceptor's backside.
†. No Connection = Standard (SS) Installation type. Connected Pin #20 to Pin #13 (GND SG) = Stacking Up (SU) Installation type.
P/N 960-000211R_Rev. A
UBA™ Pro Series Universal Banknote Acceptor
Table 2-5 Sub Board 1 USB Connector Pin Assignments
Socket (UBA Pro Side): DRA-20PC-FO (JAE)
Contact (UBA Pro Side) Pin No.1 and No.2: D02-22-22P-10000 (JAE)
Contact (UBA Pro Side) Pin No.3 - No.20: D02-22-26P-10000 (JAE)
Socket (Frame Side): DRA-20SC-FO (JAE)
Contact (Frame Side) Pin No.1 and No.2: D02-22-22S-10000 (JAE)
Contact (Frame Side) Pin No.3 - No.20: D02-22-26S-10000 (JAE)
*
I/O
-
+12V to +24V DC Power Supply
- DC Power Supply
IN Acceptor Reset Signal Line
- - No Connection
- Interface Power Supply (+12V DC)
- - No Connection
- - No Connection
- USB1 Communication Vbus Signal Line (+5V DC)
IN/OUT USB1 Communication Input/Output Signal Line
IN/OUT USB1 Communication Input/Output Signal Line
- - No Connection
- USB1 and USB2 Communication Ground (0V DC)
- 0V DC Power Supply
- LED Drive Line (Anode)
- USB2 Communication Vbus Signal Line (+5V DC)
IN/OUT USB2 Communication Input/Output Signal Line
IN/OUT USB2 Communication Input/Output Signal Line
OUT LED Drive Line (Cathode)
- - No Connection
IN
Standard (SS)/Stacking Up (SU) Selection
Function
© 2020, JAPAN CASH MACHINE CO., LTD.
2 - 7
Section 2
†