Table of Contents
Advertisement
Calibration and Testing
JCM Tool Suite Standard Edition
Mode
The following two (2) mode feature types exist in
the "
JCM Tool Suite Standard Edition
•
Normal Mode
•
Test Mode
"
" (DIP Switches All OFF) is a
Normal Mode
mode designed to provide the UBA Pro Operating
Software to be downloaded.
The "
" contains three (3) available
Service Mode
choices shown in Figure 6-9 as follows:
•
Download (for downloading software)
•
Statistics (for observing log data)
•
Utility (for ICB and Bar Ticket settings)
Figure 6-9 Normal Mode Selection
Figure 6-9 Normal Mode Selection
"
" (DIP Switch #8
Test Mode
designed to perform UBA Pro Calibration and Per-
formance Testing. The "
five (5) available choices in its Pull-down Menu
shown in Figure 6-10 as follows:
•
Download (for downloading software)
•
Statistics (for observing log data)
•
Sensor Adjustment (for calibration)
•
Performance Test (for performance testing)
•
Utility (for ICB and Bar Ticket settings)
Figure 6-10 Test Mode Selection
Figure 6-10 Test Mode Selection
Software Download
The following two (2) procedures are available to
download the Software Program with a PC (JCM
Tool Suite Standard Edition):
•
The Software Program is loaded on the Unit
(Upgrade)
•
The Software Program is not loaded on the Unit
(Initial) (e.g., after replacing the CPU Board)
To download the Software Program, proceed as
follows:
1. Remove electrical power from the UBA Pro Unit.
P/N 960-000211R_Rev. A
UBA™ Pro Series Universal Banknote Acceptor
" package:
a
) is a mode
ON
" contains
Service Mode
a
2. When upgrading the Software, set DIP Switches
as below (Figure 6-11).
Figure 6-11 Software Download (Upgrade) 1
DIP Switches All OFF (Normal Mode)
ON
1
2
3
or
DIP Switch #8 ON (Test Mode)
ON
1
2
3
Figure 6-11 Software Download (Upgrade) 1
When downloading to a Unit (software not previ-
ously installed), set the DIP Switches as below
(Figure 6-12).
Figure 6-12 Software Download (Initial) 1
DIP Switches #6, #7, #8 ON
ON
1
2
3
Figure 6-12 Software Download (Initial) 1
3. Connect the UBA Pro Unit to the PC. (Refer to
Figure 6-1 for the Tool Requirements and Har-
ness Connector locations.)
4. Apply electrical power to the UBA Pro Unit.
5. The
Green
and
Red
JCM Tool Suite Standard
6. Launch the "
" Application.
Edition
7. The Main Screen (Figure 6-13) will appear.
Figure 6-13 Software Download (Upgrade) 2
Figure 6-13 Software Download (Upgrade) 2
© 2020, JAPAN CASH MACHINE CO., LTD.
6 - 3
Section 6
4
5
6
7
8
4
5
6
7
8
4
5
6
7
8
Status LEDs will be lit.
Advertisement
Chapters
Table of Contents
