Entrance Motor Harness Assy. Removal; Centering Hp Board Removal; Figure 4-21 Centering Hp Board Removal 1; Figure 4-22 Centering Hp Board Removal 2 - JCM GLOBAL UBA Pro Series Operation And Maintenance Manual

Disassembly/Reassembly
6. Unplug the Motor Harness (Figure 4-19 a), and
feed the Harness in through the hole on the side
of the Unit as illustrated.
7. Remove the Centering Motor Harness Assy. (Fig-
ure 4-19 b).
Figure 4-19 Centering Motor Harness Assy.
Removal 4
Figure 4-19 Centering Motor Harness Assy.
Removal 4
Entrance Motor Harness Assy.
Removal
To remove the Entrance Motor Harness Assy., pro-
ceed as follows:
1. Feed the Harness (Figure 4-20 a) in though the
hole on the side of the Unit as illustrated by the
Arrow.
2. Remove the Entrance Motor Harness Assy. (Fig-
ure 4-20 b).
Figure 4-20 Entrance Motor Harness Assy.
Removal
a
Figure 4-20 Entrance Motor Harness Assy.
Removal
P/N 960-000211R_Rev. A
UBA™ Pro Series Universal Banknote Acceptor
b
a
Connector
b

Centering HP Board Removal

To remove the Centering HP Board, proceed as fol-
lows:
1. Remove the Middle Bracket Assy. (Figure 4-21
a).

Figure 4-21 Centering HP Board Removal 1

Figure 4-21 Centering HP Board Removal 1
NOTE: For the reassembly, ensure that
Middle Bracket Assy. is firmly installed in
place.
NOTE: For the reassembly, ensure that
Centering Guide R and L are symmetrically
positioned at the exact same distance from
the center.
2. Remove the single (1) Screw (Figure 4-22 a).

Figure 4-22 Centering HP Board Removal 2

Figure 4-22 Centering HP Board Removal 2
3. Remove and take the Centering HP Board (Fig-
ure 4-23 a) out through the side of the Unit as
illustrated by the Arrow.
Figure 4-23 Centering HP Board Removal 3
Figure 4-23 Centering HP Board Removal 3
© 2020, JAPAN CASH MACHINE CO., LTD.
4 - 5
Section 4
a
a
a