Disassembly/Reassembly; Tool Requirements; Uba Pro And Cash Box Removal; Led Light Module And Upper Bar Sensor Removal - JCM GLOBAL UBA Pro Series Operation And Maintenance Manual

Universal banknote acceptor
Table of Contents

Advertisement

4 DISASSEMBLY/REASSEMBLY

This section provides disassembly and reassembly
instructions for the UBA™ Pro Series Universal
Banknote Acceptor (UBA Pro).
This section contains the following information:

Tool Requirements

UBA Pro and Cash Box Removal

LED Light Module and Upper Bar Sensor Removal

Box Sensor Removal
Sub Board Removal
Main Board Removal
Centering Motor Harness Assy. Removal
Entrance Motor Harness Assy. Removal
Centering HP Board Removal
PB Encoder HP Board Removal
PB Motor Harness Assy. Removal
Stack Motor Harness Assy. Removal
Transport Motor Harness Assy. Removal
PDIC Array Removal
Lower BAR Sensor Removal
Slide Roller Removal
NOTE: Calibration is required after
reassembly. (Refer to "Calibration and
Testing" on page 6-1.)
Tool Requirements
The following tools will be required to perform
disassembly and reassembly.
#1 Phillips Screwdriver
Flat Blade Screwdriver
E-Ring Tool
Tweezer
UBA Pro and Cash Box Removal
To remove the UBA Pro and the Cash Box out of
the Frame, proceed as follows:
1. Pull the Lever (Figure 4-1 a) to release the lock.
2. Slide and remove the UBA Pro Unit (Figure 4-1
b) from the Frame (Figure 4-1 e) as illustrated by
the Arrow
.
3. Pull the Cash Box Handle (Figure 4-1 c) to
remove the Cash Box (Figure 4-1 d) from the
Frame (Figure 4-1 e) in the direction indicated by
Arrow
.
P/N 960-000211R_Rev. A
UBA™ Pro Series
Universal Banknote Acceptor
S e c t i o n 4
Figure 4-1 UBA Pro and Cash Box Removal
b
a
d
c
Figure 4-1 UBA Pro and Cash Box Removal
LED Light Module and Upper Bar
Sensor Removal
To remove the LED Light Module and the Upper
Bar Sensor, proceed as follows:
1. Remove the two (2) Screws (Figure 4-2
Figure 4-2 LED Light Module and Upper Bar
Sensor Removal 1
a
1
a
Figure 4-2 LED Light Module and Upper Bar
Sensor Removal 1
2. Release the six (6) Locking Tabs (Figure 4-3
through
a
), and remove the Top Cover (Figure 4-
6
3 b).
© 2020, JAPAN CASH MACHINE CO., LTD.
4 - 1
a
1
2
e
&
a
).
2
a
1

Advertisement

Table of Contents
loading

Table of Contents