Standard And Icb Error And Reject Code Conditions; Standard Error Code Conditions - JCM GLOBAL UBA Pro Series Operation And Maintenance Manual

Appendix A

Standard and ICB Error and Reject Code Conditions

The two (2) Status LEDs (Red and Green) indicates various combinations of solid or alternating Color
light flashing conditions when any of the Standard and ICB Error Codes listed in Table A-4 and Table A-5
occur respectively. 
Identify the cause and solution for an indicated error by comparing it against each Table A-4 and Table A-
5 listing, and ensure that the relative Assemblies are properly connected and that all of the Unit's Sensors
are clean before proceeding with troubleshooting the error condition.
NOTE: If the error is not resolved, change the relative part(s) and Sensor(s).

Standard Error Code Conditions

Table A-4 lists the various Standard LED Flash Error Code causes and solutions.
Green Red
LED LED
External Flash ROM Boot
Program ROM Check
Flashes
ON
(1)
The Boot Program is not correctly
written in ROM, or it cannot be
read.
External Flash ROM Boot
I/F Area ROM Check
Flashes
ON
(2)
The Boot Interface Area was not
written correctly or cannot be
read.
External Flash ROM Main
Program ROM Check
Flashes
ON
(3)
The Main Operating Program is
not written into the ROM correctly,
or cannot be read.
Flashes
EEPROM reading, writing and/or
ON
(4)
saving was not properly
performed.
CPU Internal RAM Check
Flashes
ON
(5)
RAM reading or writing was not
properly performed.
External SD-RAM Error
Flashes
External SD-RAM reading or
ON
(6)
writing was not properly
performed.
Backup External RAM
Flashes
ON
Backup external RAM reading or
(7)
writing was not properly
performed.
Flashes
OFF
Sensors detected that the Cash
(1)
Box is full.
Pusher Mechanism Home
Flashes
OFF
When stacking Banknotes, the
(2)
Pusher Mechanism is not
returning to the Home position.
P/N 960-000211R_Rev. A
UBA™ Pro Series Universal Banknote Acceptor
Table A-4 Standard LED Error Codes
Standard Errors
•
Error
•
•
Error
•
•
Error
•
EEPROM Error
•
•
Error
•
•
Error
•
Cash Box Full
•
•
Position Error
•
Solutions
Check that the relative parts
are properly assembled and/
or Harness are connected.
Re-download the Program.
Check that the relative parts
are properly assembled and/
or Harness are connected.
Re-download the Program.
Check that the relative parts
are properly assembled and/
or Harness are connected.
Perform the Sensor
Calibration procedure.
Check that the relative parts
are properly assembled and/
or Harness are connected.
Check that the relative parts
are properly assembled and/
or Harness are connected.
Check that the relative parts
are properly assembled and/
or Harness are connected.
Check that the relative parts
are properly assembled and/
or Harness are connected.
Check that the relative parts
are properly assembled and/
or Harness are connected.
Clean or adjust the relative
parts and Sensors.
Check that the relative parts
are properly assembled and/
or Harness are connected.
Clean or adjust the relative
parts and Sensors.
© 2020, JAPAN CASH MACHINE CO., LTD.
A - 4
Troubleshooting
Relative
Parts/Sensors
•
CPU Circuit Board
•
CPU Circuit Board
•
CPU Circuit Board
•
CPU Circuit Board
•
CPU Circuit Board
•
CPU Circuit Board
•
CPU Circuit Board
•
Pusher Mechanism
•
Stacker Motor
•
Stacker Home Sensor
•
Stacker Motor Encoder
•
Pusher Mechanism
•
Stacker Motor
•
Stacker Home Sensor
•
Stacker Motor Encoder