Taiko (Pub-7/11) Dip Switch Designations - JCM GLOBAL Taiko PUB-7 Manual

March, 2017

TAIKO (PUB-7/11) DIP SWITCH DESIGNATIONS

™
The Taiko Unit can be configured for various Communications Standards
and Protocols. Refer to the Taiko
nance Manual (JAC Part No. 960-100175R), Tables 2-5, 2-6 and 2-7 for locat-
ing specific Connector Pin designations for either Serial/MDB, CC-Talk or
Pulse communication Protocols respectively.
Communications Protocols are selected via DIP Switch settings (Table 2).
NOTE: Always check the current Taiko™ Software Data Sheets to
verify the proper DIP Switch settings required for your particular Unit.
SW No.
OFF
1
ON
OFF
2
ON
OFF
3
ON
OFF
4
ON
5
SW6
6
OFF
ON
OFF
7
ON
OFF
8
ON
Part No. 960-100919R_Rev. 1
JCM Training Overview
Table 2 Typical Taiko DIP Switch Block Settings
ON
OFF
Normal operation
Test Mode (Setting Mode)
1-time scan (without validation retry)
2-time scan mode (with validation retry)
When Pulse I/F Mode, depends on enable/disable signal.
When Pulse I/F Mode, always enabled.
1 time Spin Mode (1 Drum Rotation Cycle)
5 time Spin Mode (5 Drum Rotation Cycles - Anti-Fishing Prevention)
Serial I/F Mode (DIP Switch 8 OFF)
SW7 I/F Setting
OFF ID-003
OFF ID-0D3
ID-0E3 (without
ON
Encryption)
ID-0E3 (with
ON
Encryption)
Serial I/F Mode (Selected by DIP Switches 6 and 7)
Pulse I/F Mode
™
Series (PUB-7/11) Operation and Mainte-
DIP Switch Position Setting
4
Taiko™ Banknote Validator
Pulse I/F Mode (DIP Switch 8 ON)
SW5 PULSE WIDTH
OFF 50ms/300ms
ON 50ms/50ms
SW6 SW7 Number of PULSE
OFF OFF 1 Dollar = 1 Pulse
OFF ON 1 Dollar = 4 Pulses
ON OFF 1 Dollar = 10 Pulses
ON ON 1 Dollar = 20 Pulses
© 2017 JCM American Corporation