JCM GLOBAL UBA Pro Series Operation And Maintenance Manual page 121

Troubleshooting
Table A-6 LED Flash Reject Error Codes For Banknotes (Continued)
Green Red
Reject Errors (Banknote)
LED LED
Denomination Error
Flashes
OFF
The Sensor detected an abnormal
(7)
Banknote Type.
Flashes
OFF
While transporting a Banknote,
(8)
transparent tape was detected.
Inhibit Setting Abnormal
Flashes The Banknote Accept/Inhibit
OFF
Setting was made by a Command
(9)
from the Host Machine. DIP
Switch settings are incorrect.
Flashes
OFF
(10)
Flashes
OFF
(11)
Flashes
OFF
The Line Sensors calculated a
(13)
Banknote length longer or shorter
than the specified value.
2-Color Margin Abnormal
Flashes
The Line Sensors calculated that
OFF
(14)
the 2-Color Banknote margin was
greater than the specified value.
Counterfeiting Banknote
Flashes
OFF
(15)
The Banknote has been validated
as a Counterfeit Banknote.
3-Color Comparison
Flashes
OFF
The Line Sensors calculated a 3-
(16)
Color comparison that was
greater than the specified value.
P/N 960-000211R_Rev. A
UBA™ Pro Series Universal Banknote Acceptor
•
•
•
Photo Level Error
•
•
Contact your local JCM Representative if this error occurs.
Reserved
Contact your local JCM Representative if this error occurs.
Reserved
•
Banknote Length
Abnormal
•
•
•
•
Action
•
•
Abnormal
•
Solutions
Check that the relative parts
are properly assembled and/or
Harness are connected.
Clean or adjust the relative
parts and Sensors.
Check that the relative parts
are properly assembled and/or
Harness are connected.
Clean or adjust the relative
parts and Sensors.
Check that the Commands
from the Host Machine are
correct or change the setting to
be acceptable for use with the
Unit.
Check that the relative parts
are properly assembled and/or
Harness are connected.
Clean or adjust the relative
parts and Sensors.
Check that the relative parts
are properly assembled and/or
Harness are connected.
Clean or adjust the relative
parts and Sensors.
Check that the relative parts
are properly assembled and/or
Harness are connected.
Clean or adjust the relative
parts and Sensors.
Check that the relative parts
are properly assembled and/or
Harness are connected.
Clean or adjust the relative
parts and Sensors.
© 2020, JAPAN CASH MACHINE CO., LTD.
A - 7
Appendix A
Relative
Parts/Sensors
•
Line Sensor
•
Line Sensor
•
Command
•
Line Sensor
•
Line Sensor
•
Line Sensor
•
Line Sensor