Appendix A
Calibration Error
When an error occurs during Calibration, the spe-
cific Error Codes will be shown in a pop-up win-
dow (Figure A-1 a).
•
01-yyyy-yyyy-yyyy-yyyy (See Table A-8)
•
09-ZZ-ZZ-ZZ (See Table A-9)
•
03-00-00-xx (See Table A-10)
NOTE: If the error is not resolved, change the relative part(s) and Sensor(s).
Calibration Program Error Codes
Table A-8 lists the various Error Code causes and solutions for the Calibration Program.
Calibration
Program
01-YYYY-YYYY-YYYY-YYYY
Validation Sensor
Calibration Program process
[D/A Value, non-Paper]
failed.
02-YYYY-YYYY-YYYY-YYYY
Validation Sensor
Calibration Program process
with Paper
failed.
Barcode Sensor
Calibration Program process
failed.
UV (Reflection) Sensor
Calibration Program process
with Paper
failed.
P/N 960-000211R_Rev. A
UBA™ Pro Series Universal Banknote Acceptor
Table A-8 Calibration Program Error Codes
Error Code and
Causes
•
Check that a correct Reference Paper is placed in
a proper direction. (Refer to "Placing Reference
Paper" on page 6-5.)
•
Check that a Reference Paper is not damaged or
dirty. (Refer "Reference Paper Handling" on
page A-14.)
•
Check that the relative part is properly
assembled and/or Harness are connected.
•
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
•
Check that a correct Reference Paper is placed in
a proper direction. (Refer to "Placing Reference
Paper" on page 6-5.)
•
Check that a Reference Paper is not damaged or
dirty. (Refer "Reference Paper Handling" on
page A-14.)
•
Check that the relative part is properly
assembled and/or Harness are connected.
•
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
•
Check that a correct Reference Paper is placed in
a proper direction. (Refer to "Placing Reference
Paper" on page 6-5.)
•
Check that a Reference Paper is not damaged or
03-00-00-XX
dirty. (Refer "Reference Paper Handling" on
page A-14.)
•
Check that the relative part is properly
assembled and/or Harness are connected.
•
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
•
Check that a correct Reference Paper is placed in
a proper direction. (Refer to "Placing Reference
Paper" on page 6-5.)
•
Check that a Reference Paper is not damaged or
04-00-00-00
dirty. (Refer "Reference Paper Handling" on
page A-14.)
•
Check that the relative part is properly
assembled and/or Harness are connected.
•
Clean the relative Sensor. (Refer to "Cleaning
Procedure" on page 2-17.)
Figure A-1 Calibration Error Code Pop-Up
a
Figure A-1 Calibration Error Code Pop-Up Screen
Solutions
© 2020, JAPAN CASH MACHINE CO., LTD.
A - 1 0
Troubleshooting
Screen
Relative
Parts/Sensors
•
Line Sensor
•
Line Sensor
•
Barcode Sensor
•
UV Sensor