Connection Diagram; Modifying The Station Address - Kollmorgen Sercos II Translation Of The Original Manual

Installation / Setup
2.1.5

Connection diagram

Layout of the sercos
with S700).
2.1.6

Modifying the station address

The amplifier address can be set to a value between 0 and 63. With address 0, the
amplifier is assigned only as a repeater in the sercos
There are various ways to set the station address:
Setup software
The sercos
please refer to the online help in the Setup Software.
Alternatively, enter the command ADDR # in the "Terminal" screen, where # is the new
address of the amplifier. An amplifier SAVE and COLDSTART is required for the new
address to take affect.
Keys on the front of the servo amplifier
The sercos
amplifier. (For additional information, please refer to the instructions manuals).
14
04/2016
®
bus system in ring topology, with optical fibre cables (schematic
®
address can be modified in the setup software. For additional information,
®
address can also be modified using the keys on the front of the servo
Kollmorgen
®
ring.
®
sercos for S300/S700