Auxiliary Input Settings (Switch Mapping); Add Auxiliary Input Settings - Ag Leader EDGE User Manual

A I
UXILIARY NPUT
The Master Source drop down menu controls the master switch for your entire configuration. You may
see the following options underneath this menu:
• Switch
Controls the master switch.
• External 2
This setting can control an optional, floor-mounted master switch.
• External 1, 3 & 4
Not used at this time.
The F1-F11 cells can be assigned to any implement sections. You can use these to choose the switches
that control a particular section or controller planting clutch. From here, you can also make the following
changes to the switch settings.
• Add a switch setting. For more information, see
• Remove a switch setting.
• Reset All. This resets the settings to defaults.

Add Auxiliary Input Settings

If you wish to add a switch setting, press the Add button on the Auxiliary Input Settings Screen, and a
second Auxiliary Input Settings screen appears, as shown. This screen shows the following drop down
menus:
70
4. From here, follow the on-screen wizard's instructions to
complete the distance calibration procedure.
S (S
ETTINGS WITCH
To view Auxiliary Input Settings, go to the Planting
Configuration Tab, highlight the desired configuration and
press the Wrench button. At the Configuration Settings screen,
press the Aux Input button, and the Auxiliary Input Settings
screen appears, as shown.
This Switch Mapping function is active only for users with
DirectCommand or SeedCommand features. The Auxiliary
Input Settings screen displays settings for the Master Switch
and other switches on a SeedCommand Switch Box.
M )
APPING
"Add Auxiliary Input Settings" on page 70.