Table of Contents
Advertisement
3. Check cabling and all connections.
4. Disconnect the serial connection and determine if the controller is functioning properly without the
display.
T
ROUBLESHOOTING
O
)
NLY
Problem: The display rate and serial-controlled rate do not match.
Solution:
1. Verify the current firmware on the display and the Application Rate module.
2. Check the percent rate change. (Refer to the Quick Reference Guide for more information).
T
ROUBLESHOOTING
O
)
NLY
Problem: The display rate and serial-controlled rate do not match.
Solution:
1. Verify the current firmware on the display and the Application Rate module.
2. Check to make sure the nominal rate in the display matches the nominal rate in the serial-controlled
console.
M
ISCELLANEOUS
G
LOSSARY OF
Configuration Settings
• Rate Outside of Field
Rate that will be used outside of the field boundary. Zero stops product application. Last Good uses the
previous rate before exiting the boundary. Rx Default uses the default rate written in the prescription file
loaded.
• Rate Display Smoothing
Determines how the feedback from the control channel's rate sensor will be displayed on the run screen.
When checked, the system will display the target rate when the application rate is within 10% of the target
rate setting. When unchecked the system will display the raw feedback from the rate sensor.
• Minimum Flow
This setting is used to maintain a consistent spray pattern. The display will not allow flow to drop below the
entered setting. Set to flow at the lowest operating pressure for the selected spray tips with all sections on.
When spraying with one or more boom sections off, the system automatically reduces the minimum flow
setting according to the reduced spray width. To adjust this setting, select the keyboard button and enter
the desired numeric value.
• Controller Time Delay
Compensates for any delay in the control system when changing between different product flow rates
during variable rate application.
Speed Input Settings
• Primary Speed Source
Main speed input source used by the display.
162
S
C
ERIAL
S
C
ERIAL
A
S
PPLICATION
A
ONTROL
PPLICATIONS
A
ONTROL
PPLICATIONS
ETTINGS
(L
IQUID
(G
RANULAR
Advertisement
Table of Contents
Troubleshooting
