Save Pattern; Reset Pattern; Load Pattern - Ag Leader EDGE User Manual

Hide thumbs Also See for EDGE:

Table of Contents

Save Pattern

You can save a pattern (.pat file) to the display's internal memory to the current field by using the

following procedure.

Note: The Save Pattern button will appear when there is an active pattern.

2. Name the pattern

Press the keyboard button and enter a unique pattern name. When finished, press the green check mark

box.

Notes:

• To verify that the pattern is saved, you can open the Save Pattern screen again by pressing the Save

Pattern button. Your newly-saved or named pattern should now appear in the Save Pattern screen.

• You may remove all of the patterns by pressing the Remove All button. A warning appears, stating "All

guidance patterns will be permanently erased from memory." If you wish to do this, press the green

check mark box to continue.

3. Create new pattern (optional)

The pattern is now reset. You may now create a new pattern, if desired.

You can load a pattern from the display's internal memory to the current field by using the following

procedure.

1. Press Load Pattern

Press the Load Pattern button on the Guidance screen.

1. Press Save Pattern

The Save Pattern screen appears, as shown.

If you have been using an already-saved pattern, and wish to

switch over to a different pattern in the same field, you can use

the Reset Pattern feature by following the steps below.

1. Press Reset

Press the Reset button on the Guidance screen.

2. Confirm Reset

The Guidance screen appears, asking you to reset the current

guidance pattern. Press the green check mark box to continue.

Table of Contents