Ag Leader EDGE User Manual page 94

Note: Do not enter the number of individual rows. Enter the number of swath sections that can be
independently turned on and off.
6. Enter Section Widths from Left to Right
The Enter Section Widths from Left to Right screen appears. This screen shows the number of sections
and number of rows in your configuration. From here you can:
- Press Next, or
- Highlight the section number, and use the numeric keypad to change the section row numbers; then
press the blue right-arrow button to continue.
Note: The implement is divided up into equal section sizes by default. To modify the sections, press the
keypad button for each section that needs to be changed.
7. Enter Distance from Hitch to Application Point
Use the numeric keypad to enter the distance from the implement hitch to the application point (from front
to back). When finished, press the blue right-arrow button to continue.
8. Enter Implement Name
Use the numeric keypad to enter a name for the implement, and press the check mark box.
9. Enable Seed Row Shutoff
On the Implement Tab, first highlight the desired implement from the Implement List, then check the Enable
Seed Row Shutoff check box. Next, press the Configure Clutch Modules button.
Note: You must have the Enable Row Shutoff Module check box selected in order to have the Configure
Row Shutoff button enabled.
10. Enter number of clutch sections
Once you have pressed the Configure Clutch Modules button, the Clutch Module Configuration box
appears. Enter the same number of clutch sections that you specified in Step 5; then press the checkmark
box.
82
5. Enter Number of Implement Sections
Use the up and down arrows to enter the number of clutch sections,
and press the blue right-arrow button to continue.
11. Configuration Complete
The configuration appears, as shown.