Liquid Application Control; Liquid Application Control Configuration - Ag Leader EDGE User Manual

CAUTION: Selection of the wrong data column or unit will result in misapplication of product.
7. Default Rate Setting
The system assigns a default rate. Use the on-screen keypad to edit the value if desired.
Note: The only time the default rate is used by the display during product application is if the Rate Outside of
Field selection is set to " Rx Default". This setting is located in the equipment configuration settings portion of
configuration setup. If the Rate Outside of Field selection is set to "Rx Default", the default target rate will be
used for product application when the vehicle exits a mapped field area.
8. Name New IRX File
If desired, rename the newly created *.irx file from the system assigned default. Press the checkmark box
to complete the shape file conversion process.
L A
IQUID PPLICATION
L A
IQUID PPLICATION
The following procedure describes the complete process of configuring a Liquid DirectCommand control
system. To begin, go to the Configuration Tab, press the Add button, and the Operating Configuration
Wizard appears.
1. Select Equipment Configuration Type
Select either Single Product Application or Dual Product Application. Press the blue right-arrow button to
continue.
2. Select Vehicle
Press New to create a new vehicle, and select a vehicle from the drop-down list, then press the blue right-
arrow button and proceed to Step 2. If your vehicle is not listed, press the New button and proceed to Step
1d.
136
5. Select Equipment Configuration for Prescription
Enter the channel you wish to use for the shape file conversion.
6. Select Shape File Products and Units
From the drop-down menu on the left, select the column that
contains the product recommendation rate. The list on the right
side of the dialog shows sample data from the selected column.
Press the blue right-arrow button to continue.
C
ONTROL
C C
ONTROL ONFIGURATION
-a.Choose Vehicle Type. The Vehicle Setup Wizard appears.
Choose the correct Vehicle Type from the drop-down list and press
the blue right-arrow button.
-b.Enter Make and Model. Use the keyboard buttons to enter in the
name of your vehicle's make and model. Press the blue right-arrow
button to continue.
-c.If you selected a Self-Propelled Sprayer, you must enter a full
swath width, number of boom sections and section widths. Press the
blue right-arrow button to continue.