Add Auxiliary Input Settings; Fence Row Nozzle Indicators - Ag Leader EDGE User Manual

Hide thumbs Also See for EDGE:

Table of Contents

Add Auxiliary Input Settings

• Control Module

Specifies the function of your DirectCommand controller.

• Channel

Select the channel to control.

• F2 Switch 1

Selects the boom section to turn on and off.

You can control fence row nozzles through a DirectCommand switch box by mapping the switches in

Auxiliary Input Settings. The fence row nozzles can be mapped to any switch. Use the following

procedure to add fence row nozzles to Auxiliary Input Settings. To begin, go to the Configuration Tab.

Highlight your configuration in the Configuration List, then press the Wrench button.

2. Remove and Add Switch Settings

Use the bottom drop-down menu to select the switch you wish to adjust, then press the Add button.

106

If you wish to add a switch setting, press the Add button on the

Auxiliary Input Settings Screen, and a second Auxiliary Input

Settings screen appears, as shown. This screen shows the

following drop down menus specified for switch mapping on a

sprayer.

1. Open Auxiliary Input Settings screen

At the Configuration Settings screen, press the Aux Input button,

and the Auxiliary Input Settings screen appears.

3. Select Boom or Fence Row Nozzle

A second Auxiliary Input Settings screen appears. Use the

Function drop-down menu, located at the bottom of this screen, to

select the correct Boom or Fence Row Nozzle to be controlled by

that switch. Press the checkmark box when finished.

4. Continue Switch Setting adjustments

Repeat this process for each switch setting.

Table of Contents