Table of Contents
Advertisement
AutoSwath Notes
To use AutoSwath for planting operations, you are required to use a 5 Hz or higher GPS output rate.
AutoSwath control will not allow sections to be turned on until the master and planting section switches
are on. If you have less than a 5 Hz GPS output rate and you select AutoSwath, a warning appears,
telling you that AutoSwath Control is not available at less than 5 Hz.
Fixing Overplanting and Underplanting in AutoSwath
Turn Off Look-Ahead
Overplanting
Increase look-ahead number
The AutoSwath anticipates headlands sooner and turns the planter off sooner.
Underplanting
Decrease look-ahead number
The AutoSwath anticipates headlands later and turns the planter off later.
Turn On Look-Ahead
Overplanting
Decrease look-ahead number
The AutoSwath anticipates headlands later and turns the planter on later.
Underplanting
Increase look-ahead number
The AutoSwath anticipates headlands sooner and turns the planter on sooner.
V
T
EHICLE
this button.
• Wrench Button
The Wrench Button button opens the Vehicle Settings Screen, where you can configure GPS Offsets. For
more information, see
• Remove
The Remove button allows you to remove a vehicle.
Note: If a vehicle is deleted, all data in the regions and configurations using it will be deleted.
GPS O
FFSETS
After completing the process of setting up a Vehicle, you must also configure GPS Offsets. The GPS
Offsets define where machine rear axle, hitch, and product placement is in relation to the GPS antenna.
72
AB
The Vehicle Tab provides functionality for setting up and
configuring vehicles. The vehicle list will show any vehicles
that have already been created.
• Add
The Add button allows you to add a new vehicle. A wizard will walk
you through the vehicle setup process.
• Keyboard Button
The Keyboard button allows you to edit the name of a vehicle in the
list. To edit, highlight the name of a vehicle in the list and then press
"GPS Offsets" on page 72.
Advertisement
Table of Contents
Troubleshooting
