Direct Injection; Direct Injection Configuration Setup - Ag Leader EDGE User Manual

D I
IRECT NJECTION
DirectCommand interfaces with the Raven SCS Sidekick™ for complete control over chemical injection
applications. The display can support up to four Raven SCS Sidekick™ injection pumps plus a liquid
carrier.
D I
IRECT NJECTION
To set up a liquid application control Operating Configuration, first press the Setup (wrench) button and
go to the Setup screen.
1. Create Application Configuration
Underneath the Configuration Tab, press the Add button to add an Application Configuration.
2. Select Equipment Configuration Type
Select Dual Product Application. Press the blue right-arrow button to continue.
3. Select Vehicle or Create New Vehicle
Select the vehicle to be used in the configuration from the drop-down list. Otherwise, press the Add button
and the Vehicle Setup Wizard walks you through the steps in a vehicle configuration. These steps include
entering a Full Swath Width, entering the Number of Boom Sections, and entering Boom Section Widths
from Left to Right. Enter a Vehicle Name when complete.
4. Add Equipment for Multi-Product Application
The Add Equipment for Multiple Product Application screen appears. From here, press the Add button to
add a DirectCommand Liquid Controller.
5. Select Implement
Note: If you are using a self-propelled sprayer, skip ahead to Step 6.
If you are not using a self-propelled sprayer, the Equipment Configuration Wizard appears. From here, you
can:
• Select an Implement from the drop-down list. If you chose an already-created implement, skip ahead to
Step 6.
• Press the Add button to create a new implement, and the Implement Setup Wizard walks you through the
steps in an implement configuration These steps include selecting an Implement Attachment Method,
entering a Full Swath Width, entering the Number of Boom Sections, entering the Boom Section Widths
from Left to Right, entering the Distance from Hitch to Application Point, and entering an Implement
Name.
Press the Rate Error Alarm button. The Rate Error Alarm
screen appears, as shown.
Enter values for % Threshold and Time in seconds.
C
ONFIGURATION
S
ETUP
141