Controller Settings For Stepper Seed Rate Motor Drives; Channel Tabs; Auxiliary Tab - Ag Leader EDGE User Manual

Hide thumbs Also See for EDGE:

Table of Contents

7. Enter number of drives

Use the up and down arrows to enter in the number of hydraulic drives on your planter. Press the blue right-

arrow button to continue.

8. Enter suggested controller name

A suggested controller name appears. If necessary, use the on-screen keyboard to edit the name of the

controller.

9. Select Ground Speed Source

Select a Primary and Backup Ground Speed Source, (such as GPS, Wheels, Track or Radar). Press the

blue right-arrow button to continue.

10. Enter Suggested Name for Configuration

Use the keyboard button to enter a name for the configuration. Press the checkmark box when complete.

ONTROLLER

The Controller Settings used by operators of the Stepper Seed Rate Control feature should be set before

entering a meter calibration number or performing field operations. To begin, go to the Controller Tab

and press the Wrench Button When the Controller Configuration Screen opens, press the Controller

Settings button. The Controller Settings Screen appears, as shown. Each channel is displayed with its

own tab, and the Auxiliary Tab is where you adjust the Minimum Allowable Ground Speed.

ETTINGS FOR

• Max Meter Speed

This number represents the maximum recommended RPM of the

seed meter, and is specified by the manufacturer. A warning

informs you if this threshold is exceeded.

• Gear Ratio

The ratio of the revolutions of the hydraulic drive to turn the seed

meter one revolution.

• Minimum Allowable Ground Speed

The display will simulate this specified ground speed when you

press the Jump Start switch. This fixed ground speed setting

compensates for delays in acquiring an initial ground speed when

starting from a standstill.

TEPPER

EED

ATE

OTOR

RIVES

Table of Contents

Troubleshooting