Ag Leader EDGE User Manual page 195

• On the left-hand side of the Weight Calibration Numbers Screen is a list of grain calibration values that
range from C1 through C11. These 11 C numbers determine the weight that the display calculates from
the data that it records into your regions as you harvest. These numbers have been pre-set and you
should not change them unless instructed to by Technical Support.
• On the right-hand side of the Weight Calibration Numbers Screen, three more numeric values appear: M1,
S1, and V1. The M1 and S1 numbers are set specific to the combine model and are used for calibration.
Do not change these unless instructed to by Technical Support. The V1 number is the Vibration
Calibration number. As with the first two numbers, do not change the V1 (Vibration Calibration) number
unless instructed to by Technical Support.
4. Press New Calibration Button
To start a new calibration press the New Calibration button, located on the bottom of the Weight Calibration
Numbers Screen. After the New Calibration button is pressed, the display will apply the new moisture and
grain weight calibration from this point forward.
Note: By retiring your old calibration, you will not be able to return to your old calibration, or add data to it.
3. Press Show Cal Numbers
Press the Show Cal Numbers button, and the Weight Calibration
Numbers Screen appears, as shown.
5. Retire Old Calibration
The Retire Calibration warning screen appears, as shown. Press
the checkmark to retire your old calibration.
6. New Calibration Appears
The new calibration now appears on the Calibration Tab's drop-
down menu (A), as shown. Your calibrations, past and present, are
numbered in the order in which they were created. The calibration's
date of creation appears to the right of the name.
Perform New Weight Calibration
After you have created a new calibration, it is recommended that
you perform another Weight Calibration. Refer to
Calibration" on page 179
"Grain Weight
183