Ontrac2 Setup Tasks; Vehicle Configuration - Ag Leader EDGE User Manual

O T 2 S
N RAC ETUP
Upon installation of the OnTrac2 hardware, you must set up a new configuration using the OnTrac2
guidance feature, by performing the following tasks:
• Configure a vehicle on the OnTrac2 Configuration Tab
For more information, see
• Calibrate OnTrac2
For more information, see
included with this calibration procedure.
• Perform a Steering Diagnostics Check
For more information, see
• Adjust the tuning parameters
For more information, see
• Adjust the Response Rate and Line Acquisition Rate settings as necessary
These improve how the vehicle acquires and holds the AB line. For more information, see
Adjustment" on page 55.
V C
EHICLE ONFIGURATION
Press the Setup (wrench) tool and go to the OnTrac2 Vehicle Configuration Tab. Create an
OnTrac2 vehicle configuration.
Note: Even if you already performed a vehicle configuration in Setup, you must still perform a vehicle
configuration at the OnTrac2 Tab. The two vehicle configurations - in Setup and OnTrac2 - are independent
of each other.
1. Press the Add button
2. Choose Vehicle Style
Enter the type of your vehicle. Press the blue right-arrow button to continue.
T
ASKS
"Vehicle Configuration" on page 49.
"Calibrating OnTrac2" on page 52.
"OnTrac2 Steering Diagnostics" on page 53.
"Tuning" on page 56.
3. Enter the Wheel Base
Use the numeric keypad to enter the vehicle wheel base. Press the
blue right-arrow button to continue.
Adjusting the Disengage Sensitivity should be
"Steering
49