Configuration Settings: Equipment Configuration; Equipment Configuration Settings - Seedcommand; Speed Input Settings; Calibrate Distance - Ag Leader EDGE User Manual

C
ONFIGURATION

Equipment Configuration Settings - SeedCommand

Users of the Hydraulic Drive and Stepper Seed Meter planting configurations may adjust the following
settings at this screen:
• The Rate Outside of Field selection
determines product control channel behavior when the field boundary is exited. The drop-down menu
includes the following options:
- Zero: Product application will turn off.
- Last Good: Product application will continue at the last value used by the control system.
- Rx Default: Product will be applied at the default rate setting
• The Rate Display Smoothing check box
determines how the feedback from the control channel rate sensor will be displayed on the Map screen.
When de-selected, the system will display raw feedback from the rate sensor. When checked, the system
will display the target rate when the actual rate is within +/- 10% of the target rate setting.
• The Controller Time Delay setting
compensates for any latency in the control system when changing between different product flow rates
during variable rate application. A typical setting range for this 0-1 seconds.
S I S
PEED NPUT
The Speed Input Settings screen is where you can calibrate the ground speed input for accurate speed
and area calculations. If you are not using GPS for ground speed, then after you have created a
configuration you must calibrate the ground speed input. If you are using GPS, it is recommended to
calibrate distance in the event of GPS loss.

Calibrate Distance

1. Open Configuration Information screen
On the Configuration Tab, press on the configuration name to highlight it, then press the Wrench
Button, and the Configuration Settings screen appears.
S : E
ETTINGS QUIPMENT
The Equipment Configuration screen displays the Implement
and Controller information. The appearance of this screen may
vary, depending upon your particular planting configuration. To
edit equipment configuration settings, highlight a configuration
and press Edit.
ETTINGS
2. Press Speed Input, and the Speed Input screen appears as
shown.
3. Press the Calibrate Distance button, and the Speed Sensor
Calibration wizard appears, as shown.
C
ONFIGURATION
69