Autoswath Notes; Vehicle Tab - Ag Leader EDGE User Manual

• Coverage Option
In the Coverage Option area, you must choose between three options:
- Minimize Skip
turns off the implement section after the entire boom section is fully inside your coverage area. This
prevents the possibility of skips.
- Minimize Overlap
turns off the implement section when that boom section first enters your coverage area. This prevents
the possibility of overlaps.
- User Defined
allows you to choose what percentage of the implement section is within the coverage area before that
boom section turns off. For example, if you choose 50%, then the boom section will switch off
when half of it is within your coverage area.

AutoSwath Notes

• It is strongly recommended to use a 4 Hz or higher GPS output rate. AutoSwath control will not work until
the master and boom section switches are on. A less than 4 Hz GPS output rate can result in your boom
sections turning on and off too slow, even at speeds below 10 mph. If you have less than a 4 Hz GPS
output rate and your speed goes above 10 mph, a warning appears, advising you to use a 4 Hz GPS rate.
• If using AutoSwath on an implement that is raised out of the ground when not applying, it is recommended
to install an implement switch on the toolbar. This will prevent the system from turning on product flow
when the implement is out of the ground and the vehicle encounters unapplied area.
V T
EHICLE
• Add
The Add button allows you to add a new vehicle. A wizard will walk you through setting up the vehicle.
• Keyboard Button
The Keyboard Button allows you to edit the name of a vehicle in the list. To edit, highlight the name of a
vehicle in the list and then press this button. Then use the on-screen keyboard to edit the name.
• Wrench Button
The Wrench Button button opens the Vehicle Settings Screen, where you can configure GPS Offsets. For
more information, see
• Remove
The Remove button allows you to remove a vehicle.
Note: When deleting a vehicle all data in the regions and configurations using it will be deleted.
108
AB
The Vehicle Tab provides functionality for setting up and
configuring vehicles. The vehicle list will show any vehicles
that have already been created.
"GPS Offsets" on page 109.