Hitch Tab Settings; Implement Offsets - Ag Leader EDGE User Manual

Note: Accuracy when measuring for a specific setting is essential to ensure proper machine performance.
H T S
ITCH AB ETTINGS
Note: Accuracy when measuring for a specific setting is essential to ensure proper machine performance.
I
MPLEMENT
After completing the initial process of configuring an implement, you must enter accurate values in the
Implement Offsets screen.
To configure the Implement Offsets, you must first go to the Setup screen, press the Tillage
button and go to the Implement Tab. Highlight the implement that you wish to configure,
press the Wrench Button.
• Use the second numeric keypad to enter the distance that the swath section is located from the hitch point.
Press the check mark button when finished.
Note: Accuracy when measuring and entering implement offsets is required to ensure proper machine
performance.
The Hitch Tab is shown.
The Hitch Tab allows you to enter in the distance from four
different mounting positions on the tractor to the rear axle. Use
the number pads to enter these values in if using the hitch
point.
O
FFSETS
The Implement Information screen opens.
Press the Swath Section Offsets button, and the Implement
Offsets screen appears, as shown.
• Use the first numeric keypad to enter the distance from the mid-
point of the swath section to the machine's centerline. Select to the
left/to the right to indicate the direction the swath section is located
from the vehicle centerline.
63