Table of Contents
Advertisement
Tank Empty
The Tank Empty button, as shown at left, decreases the container level logged in the display
to zero.
Tank Partial Fill
The Tank Partial Fill button, as shown at left, increases the container level logged in the
display to specific amount that you specify in the numeric keypad. Pressing the Partial Fill
button summons the Adjust Container Amount Screen, as shown.
Adjust Container Amount
numeric keypad, where you can set a certain amount. Choose an amount that is below your maximum
container level.
Tank Alarms
The Container Alarm button, which appears at the bottom of the Container Level portion
of the Rate Screen (as shown at left), displays the capacity of your tank as well as the
percentage at which the Low Container Level warning will sound. To adjust these
settings, press the button and the Container Alarm Screen appears.
Container Alarm Screen
specified during the Controller configuration procedure.
• The Disable Low Container Level button, which appears as a bell with a red slash across it
(as shown at left), disables the Low Container Level warning.
Press the checkmark box to return to the Rate Screen.
• Add
Adds product to the container. Use the numeric keypad to enter the
amount.
• Remove
Removes product from the container. Use the numeric keypad to
enter the amount.
• Set
Sets the product level in the container. This button summons a
.
If you wish to adjust your container level warnings, use the
following buttons on the right-hand side of the Container Alarm
Screen to make these adjustments.
• The percentage (%) button sets the warning threshold according
to the percentage of solution left in the tank. In the example above,
the threshold is set at 10 percent.
• The units of measurement icon sets the warning threshold
according to the amount of solution left in the tank. This icon is
named according to the container's units of measurement you
131
Advertisement
Table of Contents
Troubleshooting
