Starter Clutch And Starter Driven Gear Bearing - Suzuki TU250X Service Manual

3-40 ENGINE

STARTER CLUTCH AND STARTER DRIVEN GEAR BEARING

1 Starter driven gear
2 Bearing
3 Roller
STARTER CLUTCH
Install the starter driven gear onto the starter clutch and turn the
starter driven gear by hand (the gear turns in only one direction).
The starter driven gear should turn smoothly. If excessive resis-
tance is felt while turning the starter driven gear, inspect the
starter clutch. Also, inspect the surface of the starter driven gear
which contacts the starter clutch, for wear or damage. If any
defects are found, replace the defective part(-s).
STARTER DRIVEN GEAR BEARING
Install the starter driven gear bearing 1 and gear 2 onto the
crankshaft and turn the starter driven gear by hand. Inspect the
starter driven gear bearing for smooth rotation and any abnor-
mal noise. If the bearing does not turn smoothly or there is any
abnormal noise, replace it.
4 Push piece
5 Spring
A Starter clutch bolt

ITEM N·m kgf-m
A
26 2.6
lbf-ft
19.0