Wiring Harness, Cable And Hose Routing; Wiring Harness Routing - Suzuki TU250X Service Manual

10-12 SERVICING INFORMATION

WIRING HARNESS, CABLE AND HOSE ROUTING

WIRING HARNESS ROUTING

Handlebar switch (RH)
Handlebar switch (LH)
1 ECM
2 Relay (Check or Main)
3 Regulator/Rectifier
4 Taping clamp
5 Wiring harness
6 Clutch cable
*1 Cut off the excess end of clamp.
The tip of clamp must face
*2
upward.
Clamp
Clamp
Wiring harness
*1
*1
Clamp
Clamp
Wiring harness
Clutch cable
Guide
Wiring harness
Clutch cable
20 mm
(0.8 in)
Wiring harness
Starter motor
Clamp
*3 Pass the wiring harness outside of the air cleaner bracket.
Set the fuel pump coupler at the right side of IAT sensor.
Do not pinch the fuel pump lead wire coupler between the fuel
*4
tank and frame, when installing the fuel tank.
Pass the neutral switch lead wire and generator lead wire
*5
inside of the air cleaner bracket.
Before clamping the lead wire, draw the protector tube to the
*6
rear turn signal lead wire coupler.
*7 Pass every wiring harness inside of the relay.
*4
*5
*3
Wiring harness
Clamp
*2
Clamp
Clamp
Wiring harness
Wiring harness
STVA
STP sensor Generator
Neutral switch
Side-stand switch
*7
Clamp
Rear turn signal (RH)
*1, *6
*6
Rear turn signal (LH)
Rear combination
Clamp
8 N . m (0.8 kgf-m, 6.0 lbf-ft)