Suzuki TU250X Service Manual page 240

8-20 CHASSIS
• Tighten the brake lever pivot bolt 7 and lock-nut 8 to the
specified torque.
 Front brake lever pivot bolt: 6 N·m (0.6 kgf-m, 4.5 lbf-ft)
Front brake lever pivot bolt lock-nut:
• When installing the master cylinder 0 onto the handlebar 9,
align the master cylinder holder's mating surface with punch
mark C on the handlebar and tighten the upper holder bolt A
first as shown.
 Front brake master cylinder holder bolt:
• Install the brake hose union as shown and tighten the union
bolt B to the specified torque.
 Front brake hose union bolt:

* The seal washers should be replaced with new ones
to prevent brake fluid leakage.
* Bleed air from the brake system after installing the
master cylinder. (2-16)
6 N·m (0.6 kgf-m, 4.5 lbf-ft)
10 N·m (1.0 kgf-m, 7.0 lbf-ft)
23 N·m (2.3 kgf-m, 16.5 lbf-ft)
"UP" mark
Clearance
20 – 30˚