Suzuki TU250X Service Manual page 105

3-58 ENGINE
• Install the washers 3, crank balancer driven gear 4 and
shim 5 as shown.
NOTE:
Align the punch mark A on crank balancer driven gear with the
punch mark B on crank balancer drive gear.
CRANKCASE
• Clean and degrease the crankcase mating surfaces (both sur-
faces).
• Apply engine oil to the O-rings 1 and install them.

Replace the O-rings with new ones.
• Apply engine oil to the gears and bearings.
• Install the dowel pins into the left crankcase.
• Apply bond to the both crankcases.
 99000-31110: SUZUKI BOND "1215" or equivalent

* Coat the sealant evenly without break.
* Application of sealant must be performed within a
short period of time.
* Take extreme care not to let sealant enter into the oil
hole or bearing.
• Assemble the crankcases with in few minutes.
Right crankcase
Left crankcase