Inspection And Disassembly - Suzuki TU250X Service Manual

8-48 CHASSIS

INSPECTION AND DISASSEMBLY

WHEEL (2-19)
TIRE (8-59)
SPOKE NIPPLE (2-20)
REAR AXLE
Measure the rear axle runout using the dial gauge.
If the runout exceeds the service limit, replace the rear axle with
a new one.
 Axle shaft runout
Service Limit: 0.25 mm (0.010 in)
 09900-20607: Dial gauge
09900-20701: Dial gauge chuck
09900-21304: V blocks
WHEEL DAMPER
Inspect the dampers for wear or damage.
Replace the damper if there is anything unusual.
DUST SEAL
Insect the dust seal lip for wear or damage.
If any defects are found, replace it with a new one.
• Remove the dust seal with the special tool.

The removed dust seal must be replaced with a new
one.
 09913-50121: Oil seal remover