Turning Power On/Off - NTT docomo STYLE Series Instruction Manual

: Wait approximately 2 seconds and the display disappears.
: The battery level sound is heard at the volume set in Key/
Standby i-motion (nP. 86).
If battery runs out
[Battery empty. Unsaved data will be lost. Ending
current operation] appears if battery starts to run out
(Press t to clear the message). After a while, an
alert tone sounds. The warning screen stating that
the battery runs out appears, handset operations are disabled and
power turns off after approximately 60 seconds.
During a voice/Videophone call, the alert tone sounds and [Battery
empty. Unsaved data will be lost. Ending current operation]
appears. The call is disconnected after approximately 20 seconds.
At the same time, the screen above appears and after
approximately 60 seconds, the power turns off.
Alert tone does not sound when Manner mode or Public mode
(Drive mode) is set (Alert tone sounds during a call).
Power ON/OFF

Turning power ON/OFF

Turning power ON
1
Press H (for 2+ seconds).
: It may take some time for the wakeup screen to appear.
: The wakeup screen appears followed by the initial settings
screen. Proceed to Initial setting (nP. 44).
: If initial settings have been completed, the
screen shown on the right appears when
power is turned on. This screen is called the
"stand-by display".
Welcome mail
: "Welcome$デコメアニメ%&"
(Welcome$Decome-Anime%&) and "緊
急速報 「エリアメール」 のご案内"
(Information of Early Warning "Area Mail")
are saved by default.
: To check a welcome mail: In stand-by,
press t/select the stock icon C (mail
message)/t.
• For details on the following operations nP. 134
If initial settings are not yet completed, the setting screen appears
every time the power is turned on.
If the FOMA card is not inserted, [Insert UIM] and a FOMA card
error appear (nP. 30).
When [Enter PIN1 code] appears, enter the PIN1 code
(nP. 105).
When a FOMA card is replaced with a new card, the terminal
security code (four to eight digits) must be entered after turning on
the terminal. If a correct terminal security code is entered,
stand-by display appears. When a wrong terminal security code is
entered five times, the power is turned off. However, turning on the
power again is possible.
When A appears, the handset is outside the service area or in a
place with no signal. Move to a place where the icon disappears.
Turning power OFF
1
Press H (for 2+ seconds).
: It may take some time for the power to be turned off (The end
screen appears on the display until the power is turned off).
Stand-by display
43