NTT docomo STYLE Series Instruction Manual page 346

■ Setting alarm from stand-by
1
In stand-by, enter a time (four digits: 24-hour
format)/t/[Quick alarm].
Schedule is registered for the current day (following day if the time
has already passed), [No category] for the category, and [Quick
alarm] for the message.
When set time arrives
Alarm is activated in accordance with the settings. If a contact is
saved, the contact information appears when the alarm is stopped.
To make a call to the saved contact: Display the
make a call.
• The phone number or name (if it is saved in the phonebook)
appears in the contact. When the name appears, press t to
display the phonebook entry details screen (nP. 79).
When the FOMA terminal is closed, [Alarm] appears in the sub
display.
Once the alarm duration has elapsed, the alarm stops and the
specified message appears.
Key operation when an alarm sounds
To stop alarm (snooze activated)
To stop alarm (snooze disabled)
To adjust volume (volume 0 to 10)
* Adjusting the volume is not available when volume is set to Step.
When the FOMA terminal is closed, press & to stop alarm (Snooze
is activated).
344
<Quick alarm>
contact/t/
1 to 9, 0, *, #, t, v,
i, C, m, a, s, c, $, {
H
u
*
The alarm is not activated when the set time arrives in the
following cases. Upon the end of the call or the operation, the
previously displayed screen or the stand-by display is returned,
and the alarm is activated.
During a call
During Ir communication
During iC communication
During microSD mode/MTP mode
While software is being updated*
* When the set time arrives while the software is being updated,
the alarm may not be activated, even when the updating ends.
When a call is started during snooze, snooze notification is
interrupted. After the call ends, snooze notification resumes.
During snooze or while the alarm for which snooze is set is
sounding, other alarm/schedule alarm do not sound, even when
the set times arrive.
While Manner mode is set with vibration [ON], vibrator operates in
[Pattern1] even if vibrator is set to [OFF].
When a phonebook entry with Picture call applied is set as a
contact
The picture call image appears when the alarm is activated.
When an i-motion is set for Picture call, the regular alarm screen
appears.
When an i-motion with image and voice is set as alarm tone, the
i-motion image takes priority.
When alarm time arrives while 1Seg is being watched
Multi Window appears and the alarm is activated. When alarm
ends, the handset returns to the status existing before the alarm
was activated.
Disabling/Deleting/Changing alarm settings
Set (Change)/Disable/Delete alarm settings individually. Details are
erased when alarm is deleted. Details are retained when disabled. To
use the same details, set again.
While receiving a mail
During packet transmission
While using Infrared remote control